UVB Meter, UVB detector, sun light tester, reptile climbing pet special UVB tester
Features
Use imported sensor, no stray light effect
Can be over-measured, with small measurement error
Advanced circuit design to reduce interference
LCD
Simple operation and durability
High cost performance
Recommendations
Before measuring the UV lamp, be sure to take the necessary protective measures and wear UV protection glasses.
Please preheat the UV lamp for at least 5 minutes.
In order to improve the accuracy of measurement data, multiple measurements can be used to reduce the error.
Please keep the sensor clean. For cleaning, wipe with alcohol and cotton yarn. Do not use sharp objects to clean the sensor to prevent damage to the front filter.
Operation guide
Align the sensor probe above the irradiance meter with the UV light source and press the front button to read the light intensity value on the LCD screen. Make a note of the distance between the point and the UV light source. After a long time of multiple measurements, the attenuation process of the UV light source can be obtained. After the light intensity is attenuated to about 70%, the UV light source is replaced to ensure the irradiation intensity.
This product is powered by 3V DC. Two AA batteries are included with the irradiator. If it is not used for a long time, please take out the battery to avoid leakage damage to the irradiator.
Product parameters
Response spectrum 280-320nm
Peak spectrum λp=300nm
Measurement interval 0-1999μW/cm2
Resolution 1μW/cm2
Response time T≤0.5s
Measurement accuracy ±10%
Built-in power supply DC3V
Operating power consumption ≤ 0.25W
Weight (with battery) 125g
Product size 135×70×24 (mm)
Screen size 2 inches
Probe material UV glass
packing list
One RGM-UVB host
AA battery two sections
Orange protective cover
One copy of the product manual
One factory certificate
Reviews
There are no reviews yet.