Banner Welders/PVC Welding Machines for PVC cards

1, Wleding without glue, save cost and protect environment.

2, The theory is based on digital control constant temperature to make the temperature more constant automatically.

3, The speed is 6-10m per minute.you can adjust the speed according to setting temperature and the thickness of picture.

4, Temperature scope is 50-500℃, Temperature can be set according to the thickness of picture.

5, R & D capacity: Our company has all the key technology, the quality of the machine is in control, we also have CE certification.

6, Power:1000-1600W, After Setting the desired temperature, it will automatically adjust the power according to the temperature.

7, Hot air speed of hot air gun .50-100% of the wind speed can be adjusted, so you can fight a thick picture to ensure easier, and the heater parts live longer.

8, Heater Equipped with AC motor and it makes wind stronger, life longer, cost low.
9, Heating wire: The quality of imported heating wire is more reliable and longevity.

10, POWER:DELL Original Laptop Power,EMC is Good and quality is reliable that meet with European and American standards.

 How to operate it? 

1. First, make the picture smooth and tight, take jointer to accurate (about 2-4cm), fixed edges with tape or glue on the ground.

2. Open the power, turning handle to left to keep hot air nozzle and the rubber tire is on the straight line. Then turn the right black knob to adjust the speed, generally marked on the knob points to the location between 2 from 4.After setup, turning the handle to right until the hot air out of the ground.

3. Set the temperature degree. Open temperature switch, And turn the golden knob until it clicks and then follow the button to the end.set the desired temperature according to thickness of picture. In general, the temperature is between 300-350 degree Or taking some picture material to aligned nozzle, If it can be melted immediately, This temperature is the one you need and to set.

4. In the welding process, if printing material is burnt, the first thing to slow down the speed or low the temperature,This can avoid to burnt picture material,but do not increase speed rapidly, otherwise the machine will run too fast to make it go straightly,this will cause the picture can not be spliced and damage the picture.

5. Before using, please find the proper temperature and speed according to your printing material. If the speed is too slow it could burn the picture, while too fast to welding strong. Therefore, It is very important that the temperature and speed are good match.

6. After welding, turning the handle to right to keep hot air gun from picture completely,then turn off the temperature switch(Left the gold knob until it make a voice of clicks).No lugging the power cord and turning the power off directly,to avoid heat damage to the hot air gun,After temperature of the machine must be reduced to below 50 degree.you can cut off the power or main switch.

7. Don’t use it in rainy day,the workplace should be dry, flat and safety of fire.The machine should have technical person to operate, it is forbid that someone use it without specific knowledge. Working voltage:110V—220V. Strictly prohibited without permission disassemble,you should be responsible the result yourself.

 Back to Home !